Protection Circuit Module (PCB) for 1 cell (3.2V) LiFePO4 Battery Pack at 2.5A limited (#6086)

Protection Circuit Board Specifications  For 3.2V LiFePO4 Battery  Pack
Model: PCB-LFP2.5AS1
No.	Test   item		Criterion
1	Voltage	Charging voltage	DC: 3.6V CC/CV
		Balance voltage for single cell	N/A
2	Current	Balance current for single cell	N/A
		Current consumption for single cell	≤10μA
		Maximal continuous Charging current	2.5A
		Maximal continuous discharging current	2.5A
3	Over charge Protection (single cell)	Over charge detection voltage	3.90±0.025V
		Over charge detection delay time	0.96S-1.4S
		Over charge release voltage	3.80±0.025V
4	Over discharge protection (single cell)	Over discharge detection voltage	2.0±0.05V
		Over discharge detection delay time	115—173mS
		Over discharge release voltage	2.3±0.05V
5	Over current protection	Over current detection voltage	0.1V±0.15V
		Over current detection current	2.5-3.5A
		Detection delay time	7.2ms-11ms
		Release condition	Cut load
6	Short protection	Detection condition	Exterior short circuit
		Detection delay time	100-500us
		Release condition	Cut load
7	Resistance	Protection  circuitryB- TO P-	≤50mΩ
8	Temperature	Operating Temperature Range	-40+85
		Storage Temperature Range	-40+125
9	Weight		0.1Oz (2.8 grams)
10	Dimenstion	Dia x T	21 x 4 mm
11	Specification in pdf file	Download the specification

 For other PCM/PCB, please check our PCM/PCB/BMS/CMB/UPS category

Warning

• If you want to use this protection circuit board for a battery that is less than the rated drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch. 
• You must be professional in Lithium battery pack to buy the protection circuit board. Misusing may cause battery damage or explode. We are not responsible for any damage caused by user.