Protection Circuit Module (PCM) with Equilibrium function for 59.2V Li-Ion Battery Pack at 100A rate (#1080)
This protection circuit is specially designed for 59.2V (16S) Li-Ion Battery pack with 100A discharging rate. Different than normal PCB, it provides equilibrium function after battery pack is fully charged. PCM will detect each cell's voltage and trim higher voltage down until other cells reach the same voltage level. Therefore, it helps Li-Ion cells have longer service life.
| Protection Circuit Module Specifications For 59.2V Li-ion/Li-Po Battery Pack | |
| ModelPCM-LI59.2V100A | |
| Over-charge detection voltage | 4.25V±0.025V |
| Over-discharge detection voltage | 2.50V±0.07V |
| Over-current detection protection | 350±30A |
| Balance Voltage for single cell | 4.2V±0.03V |
| Balance current for single cell | 85mA±5mA |
| Maximal continuous charging current | 40A |
| Maximal continuous Discharging current | 100A |
| Current consumption for single cell | ≤20uA |
| Short circuit detection condition | Exterior short circuit |
| Protection circuitry resistance (B- TO P-) | ≤30mΩ |
| Dimension (L x W x T) | 192mm x 137 mm x 45mm |
| Weight | ? |
| P+/P- | P+ = B+ / Charge+ / Discharge + |
| Specification | Download Specification |
For other PCM/PCB, please check our PCM/PCB/BMS/CMB/UPS category
Warning
- If you want to use this protection circuit board for a battery that is less than the rated drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch.
- To achieve balance, each cell in battery pack must has equal voltage within tolerance. When charger LED turn Green, allow 30 minutes for pack to balance before use.
- You must be professional in Lithium battery pack to buy the protection circuit board. Misusing may cause battery damage or explode. We are not responsible for any damage caused by user.